ART M-Two Cardioid FET Condenser Mic

Versatile side-addressed condenser with built-in pad and low-frequency filter. Comes with shock-mount & case.

As a cardioid condenser microphone the M-Two picks up only sound directly in front of the mic while sounds from sides and back of the microphone are rejected increasing isolation and delivering controlled directionality.

Vocalists can use the proximity effect to their advantage, adding fullness and more 'bottom end' to the voice. Experienced vocalists can easily incorporate it as part of their overall microphone technique

Controls on the microphone itself include a -6 & -12dB pad switch, allowing distortion-free reproduction of extremely loud at-source signals, and a two position -12dB/octave low frequency roll off at 100Hz & 200Hz that reduces unnecessary low end 'boominess' and low frequency interference.

The microphone’s chassis is precision-tooled zinc/aluminium alloy with a dent resistant stainless-steel wire-mesh windscreen. The included heavy-duty shock-mount suspension virtually eliminates vibration and handling noise, while at the same time safely securing the microphone in any position needed during the recording process.

Features

• Wide Diaphragm Cardioid Studio Condenser Microphone
• Dual Position -6dB & -12dB Pad Switches
• Dual Position -12dB/Octave 100Hz & 200Hz Low Frequency Roll-Off Switch
• Warm, Smooth-Sounding Low Noise Circuit Design
• Dual 32mm Low Mass Gold Sputtered Diaphragm Capsule
• Aluminium Carrying Case & Deluxe Cradle Shockmount Included

Model:  498
Manufacturer:  ART
Mic Type:  Condenser
Polar Pattern:  Cardioid
Frequency Response (Hz):  20-20,000
Sensitivity (mV/Pa):  35
S/N Ratio dB(A):  78
Impedence (Ohm):  200
Maximum SPL (dB):  135/147
Power Requirements:  48V Phantom Power
Connection:  XLR 3-Pin
Pad Attenuation (dB):  -6/-12
High-Pass Filter (Hz):  100/200
Included Accessories:  Carry Case, Shockmount

Be the first to Write a Review for this item!